Seals for refrigerators
 |
 |
 |
 |
You need to determine what type of seal mount is on your refrigerator:
"For gluing"
The profile is glued or screwed along the perimeter of the door (Nord, Dnepr, old Snaig and many others)
“Under the bar”:
a) The seal is glued between the door and the plastic inner panel of the refrigerator door using mounting foam, also known as polyurethane foam – Stinol, Indesit refrigerators, etc.
b) The seal is screwed on with self-tapping screws (screws) through the plastic inner panel of the door and pressed with a metal plate “bar” – refrigerators Polyus, Biryusa, etc.
When bending the profile to the left or right, the seal will bend only in one direction, since it is tucked with its “tail” under the strip and glued or screwed on with self-tapping screws.
The height and width of the sealing frame are measured along the outer contour of the seal.
“Into the groove”:
It is inserted into the mounting groove located around the entire perimeter of the door.
When bending the profile to the left or right, the seal will bend evenly (equally) in both directions, since the “arrow” of the seal protrusion is usually located in the center of the seal.
If you have already found your seal in our catalog of seals , place an order on the website, we will call you/write and send the order
If you need help in choosing a seal, prepare a photo of the refrigerator nameplate, the dimensions of the seal along the outer edge, and show them on Viber/Telegram/WhatsApp in the contacts section
In most cases, our seal is attached to the door with glue, adhesive tape or screws, clamped with strips or inserted into the door groove.
For mounting the seal
it is necessary to remove the door and lay it horizontally. Prepare a flat surface 3-5 cm wide around the entire perimeter of the door (remove the old seal, clean off the remains).
Fix the seal (with the fastening collar, not the magnetic side!) to the plane of the door perimeter with glue or self-tapping screws (if necessary, pre-drill holes). Then, when installing the door, adjust the uniform fit of the door to the refrigerator body with the bolts on the door hinges.
If the seal is inserted into a door groove, first insert the seal only at the corners, then press it in at the centers, then between them, and so on, leveling it evenly.
If the seal does not fit you , you were unable to install it, you made a mistake with the dimensions or with the type of seal and you want to return it, we can determine the amount of compensation only after inspecting the return.
BECAUSE
The refrigerator seal is very fragile and loses its commercial properties when transported repeatedly and if installed and packaged incorrectly.