Restoration of a pump rotor or water pumping station
Unfortunately, it is becoming increasingly difficult to buy a new pump rotor from BCN (HELZ), Sprut, Kenle, Wilo, Karcher or something else. It’s not a problem, since you have our master. If the shaft of your rotor is damaged by corrosion, the reinforcement does not hold the vise, it is necessary to work properly.
We will replace the damaged shaft part with a new steel, stainless or brass one.
To restore your rotor , you need to send it to us at the mechanic, for whom write or call for contacts .
Please be respectful of the following: we are changing the shaft based on the obvious geometry of your original shaft. If there is a lot of damage to the table, its geometry is no longer visible, we are based on our research and statistics on the repair of similar rotors. If you have a broken section of the shaft, or a nut or impeller, on the stand on which you can update various parameters of the shaft, place them in the frame. You can also give us a chair.
In the chair, indicate the full length of the shaft, the diameter of the bearing seat, the diameter of the oil seal seat, the diameter of the thread (as indicated), the presence of a cut in the retaining ring (as indicated)
The turnaround time is 1-4 weeks, depending on the equipment setup
Here you can look at the butts of Vikon's rotor repair robots